Develop Embedded Systems using Embedded C on AVR

About Develop Embedded Systems using Embedded C on AVR

Learn Embedded C with AVR Microcontrollers!!

8.5 Hours of Video Content.

8 Quizzes with more than 70 Questions.

13 Hands-on Practicals

All Codes are available in the resources

Lecture Material (PDF / PPTs) are available in the resources

All Wiring Diagrams are available resources

Description

This course Demystifies the internal working of Microcontroller and Peripherals. You will learn register-level Embedded C programming to use inbuilt peripherals on the microcontroller to interface

sensors, actuators, and Liquid Crystal Displays (LCD)

. You will learn to use

Timers

to generate accurate

delays

, Use timers to generate

Pulse Width Modulation (PWM)

Waveforms with variable duty cycle. Learn to use

analog to digital converter (ADC)

to gather data from analog sensors and display it to LCDs. Each section ends with a Quiz to examine your learning outcomes from this course. All the codes (

C Programs) are available

in resources along with the

lecture material.

This is

NOT Arduino Style Programming!!

I believe that Arduino is for quick prototyping of products but not for

Mastering Microcontrollers and peripherals.

In Arduino, you use many

Third-Party Libraries,

In this course, you will be writing your own libraries, Your code will be talking and manipulate

microcontroller registers, True Register Level programming

is presented in this course

.Major Topics Covered

1.

Masking:

Learn to manipulate (Set/Reset) a particular bit in a port or MCU register without altering other bits. 2.

Pull-up Register:

Learn the importance of pull-up resistors, enabling and disabling them, also learn to use them in interfacing digital sensors. 3.

Timers:

Learn to write C programs to generate accurate delays using MCU Timers. 4.

Pulse Width Modulation:

Learn to generate PWM wave with variable duty cycle using MCU timers and PWM registers. 5.

Liquid Crystal Display:

Learn to interface LCDs with MCU using GPIOs, No third-party library is used for LCD, You will learn to write your own library for LCDs. 6.

Analog to Digital Converter:

Learn to interface analog sensors such as a potentiometer to read voltage across it. 7.

Temperature Monitoring System:

Learn to interface LM35 temperature sensor IC to read ambient temperature and display the same on LCD. 8.

Speed Control of DC Motor:

Learn to control the Direction and Speed of DC Motor using half-bridge integrated circuit

L293D

and PWM Technique. Vary the Speed using a POT connected to ADC and vary the PWM duty cycle accordingly.